1.Warnings
1． DO NOT allow another person to stand in front of or behind lifter when it starts to move.
2． ALWAYS travel with table in lowered position. Load could fall down.
3． NEVER sit, stand or ride on platform. SEVERE PERSONAL INJURY could result.
4． NEVER go under platform. SEVERE PERSONAL INJURY or DEATH could result.
5． DO NOT use in area of multilevel floor surface that could create loss control and result in
SEVERE INJURY and PROPERTY DAMAGE.
6． DO NOT use lifter on slope, uneven or soft surface. Lifter may become uncontrollable.
SEVERE PERSONAL INJURY and PROPERTY DAMAGE could result.
7． KEEP FEET CLEAR of rolling wheels that could result in SEVERE PERSONAL INJURY.
8． DO NOT load one fork more than the other and DO NOT load tips on table. SEVERE PERSONAL INJURY
and PROPERTY DAMAGE could result.
9． DO NOT overload lifter. ALWAYS stay within designated capacity and load center rating.
SEVERE PERSONAL INJURY and PROPERTY DAMAGE could result.
10． SHEARING HAZARD. NEVER place hands or feet under lowering table. SEVERE PERSONAL
INJURY could result.
11． NO FIRE during charging. Read battery operation manual.
12． HIGH VOLTAGE. Disconnect battery socket before opening control panel box.
13． DO NOT remove battery terminal cover. Short-circuit or electric shock could occur.
2.Cautions
1 Warnings
2 Cautions
3 Name of Parts
4 Daily Inspection
5 Operation Instruction
6 Structural Data Form
7 Maintenance
8 Hydraulic Circuit
9 Parts List
Page 1
Page 1
Page 2
Page 2
Page 2
Page 4
Page 4
Page 5
Page 6
1
1. Read the operation manual completely before using and thoroughly understand and follow all safety
instructions.
2. This lifter is designed to use with stable uniform load on a solid lever floor. DO NOT use the lifter for any
other purpose than its intended use.
3. TRAINED personnel shall operate lifter only. OPERATOR shall read “Operation Manual” completely and
thoroughly understand the controls and operation of this equipment BEFORE operating the lifter.
4. ALWAYS observe lifter and ALWAYS stay at the controls while the lifter is in motion, RELEASE controls
and STOP lifter immediately if load on lifter appears to become unstable. NEVER leave the loaded lifter
unattended unless the table is in the fully lowered position and the lifter is locked reliably.
5. DO NOT slide the load on or off the table. The lift may move allowing the load to fall. SEVERE PERSONAL
INJURY and PROPERTY DAMAGE could result.
6. DO NOT use lifter with unstable, unbalanced or loosely stacked load. Unbalanced loads may become
unstable and fall. SEVERE PERSONAL INJURY and PROPERTY DAMAGE could result.
7. Qualified personnel must perform ALL lifter service only.
8. ALWAYS keep feet, hands and fingers away from casters, load wheels and all moving components.
SEVERE INJURY could result.
9. ALWAYS perform maintenance and inspections with lifter unloaded.
10. Prolonged continuous working might cause damage of power pack.
11. Stop operation if temperature of hydraulic oil is too high.The lifter is NOT waterproof and is intended to be
used in a dry environment.
CONTENTS
