31
Checking
Checking
Checking
Checking electrical
electrical
electrical
electrical fuses
fuses
fuses
fuses
– Prepare the truck for maintenance and
repairs (See 5.3.3 Maintenance
Instructions
Page28 ).
– Dismantle the front panel.
– Check rating of all fuses in accordance
with table, replace if necessary.
Item
To protect:
Rating
1
Traction / Lift motor
200A
2
Controller
15A
Recommissioning
Recommissioning
Recommissioning
Recommissioning
The truck may only be recommissioned
after cleaning or repair work, once the
following operations have been performed.
– Test horn.
– Test Emergency brake switch.
– Test brake.
– Lubricate the truck in accordance with the maintenance schedule.
5.4Decommissioning
5.4Decommissioning
5.4Decommissioning
5.4Decommissioning the
the
the
the industrial
industrial
industrial
industrial truck
truck
truck
truck
If the industrial truck is to be decommissioned
for more
than two months , e.g.
foroperational reasons,it must be parked in a frost-free and dry location and
allnecessary measures must be
taken before, during and after decommissioning as
described.
On decommissioning the truck must be jacked up so that all the wheels are clear of
the ground. This is the only way of ensuring that the wheels and wheel bearings are
not damaged.
If the truck is to be out of service for more than 6 months , further measures must be
taken in consultation with the manufacturer’s service department.
5.4.1Prior
5.4.1Prior
5.4.1Prior
5.4.1Prior to
to
to
to decommissioning
decommissioning
decommissioning
decommissioning
– Thoroughly clean the truck.
– Check the brakes.
– Check the hydraulic oil level and replenish as necessary (See 5.3.3 Maintenance
Instructions Page28 ).
– Apply a thin layer of oil or grease to any non-painted mechanical components.
