16
The program is divided into 30-second segments.
One target heart rate setting is programmed for
each segment. Note: If the CONSTANT PULSE
program is selected, the same target heart rate
setting is programmed for all segments.
At the end of each segment, a tone will sound and
the resistance of the pedals will automatically
change, if necessary, to bring your heart rate
closer to the target heart rate setting for the next
segment. The program will continue in this way
until the last segment ends.
During the program, you can change the resis-
tance of the pedals, if desired, by pressing the
RESI and – buttons or the QUICK-
TOUCH RESISTANCE buttons. However, when
the current segment ends, the resistance will auto-
matically change, if necessary, to bring your heart
rate closer to the target heart rate setting for the
next segment. Note: Each PULSE program ends
with a two-minute cool-down period. During this
period, the resistance level cannot be changed.
If your pulse is not detected during the program,
the letters “PLS” will flash in the main display, and
the resistance of the pedals may automatically de-
crease. If this occurs, see THE PULSE SENSOR
on page 11.
Follow your progress with the main display.
See THE MAIN DISPLAY on page 10.
When you are finished using the elliptical ex-
erciser, the console will automatically turn off.
See HOW TO TURN OFF THE CONSOLE on
page 9.
HOW TO USE THE INTERVAL PROGRAM
The INTERVAL program will automatically change the
resistance of the pedals to simulate a series of hills as
it guides you through an effective interval training
workout.
Begin pedaling to activate the console.
See HOW TO ACTIVATE THE CONSOLE on
page 9.
Select the INTERVAL program.
To select the INTERVAL program, press the IN-
TERVAL button. The indicator on the button will
light, and the word “INTERVAL” will appear in the
main display for a moment.
Enter your age.
See step 3 on page 13.
Enter your weight.
See step 4 on page 13.
Enter a program time.
See step 5 on page 13.
Enter a maximum resistance setting.
See step 6 on page 14.
Enter the desired number of hills for the
program.
Next, the words “NUMBER HILLS” and the num-
ber of hills that the program will simulate will ap-
pear in the main display. If you wish to change the
number of hills, press the + and – buttons beside
the ENTER button. When the desired number of
hills is shown, press the ENTER button.
7
6
5
4
3
2
1
9
8
