10
7
7. While a second person holds the Upright (4)
near the Frame (1), locate the wire tie in the
Upright.
See the inset drawing.
Tie the lower end of the
wire tie to the Main Wire Harness (110).
Pull the upper end of the wire tie until the Main
Wire Harness (110) is routed through the
Upright (4).
Tip: To prevent the Main Wire Harness (110)
from falling into the Upright (4), secure the
Main Wire Harness with the wire tie.
110
4
1
110
Wire Tie
Wire Tie
Wire
Tie
8.
Tip: Avoid pinching the Main Wire
Harness (110).
Slide the Upright (4) onto the Frame (1). Attach
the Upright with seven M8 x 16mm Screws (72);
do not fully tighten the Screws yet.
Do not press the Shield Cover (75) into
place yet.
8
1
72
72
72
4
75
110
Avoid pinching
the Main Wire
Harness (110)
