12
11. Apply a small amount of grease to a Pedal Arm
Axle (24).
Insert the Pedal Arm Axle (24) into the Right
Pedal Arm (58) and the Right Roller Arm (45).
Next, tighten an M10 x 16mm Screw (33) with an
M10 x 25mm Washer (148) into each end of the
Pedal Arm Axle (24)
at the same time.
Then, tighten the indicated M8 x 16mm
Screw (72).
Repeat this step on the left side of the
elliptical.
11
10
10. Using a plastic bag to keep your fingers clean,
apply a generous amount of the included
grease to the Arm Axle (35) and to two Wave
Washers (95).
Insert the Arm Axle (35) into the Upright (4) and
center it. Then, slide a Wave Washer (95) onto
each end of the Arm Axle.
With the help of a second person, slide the Right
Upper Body Leg (36) onto the right side of the
Arm Axle (35). Move the Right Pedal Arm (58) to
the right, and set it on the floor;
do not set it on
the Ramp Top Cover (10).
With the help of a second person, slide the Left
Upper Body Leg (46) onto the left side of the
Arm Axle (35), and set the Left Pedal Arm (44)
on the floor;
do not set it on the Ramp Top
Cover (10).
Then, tighten an M8 x 16mm Screw (72) with an
M8 x 23mm Washer (98) into each end of the
Arm Axle (35)
at the same time.
35
Grease
95
95
36
98
148
148
98
46
72
58
44
33
45
24
33
72
Grease
Grease
58
10
72
4
