10
9. Apply a film of grease to the barrel of an M8 x
55mm Bolt Set (82) and to a 7mm Spacer (55).
Slide an M8 Washer (69) and the Spacer onto
the barrel of the Bolt Set.
While another person holds the front end of the
Left Pedal Leg (14) inside the bracket on the left
Handlebar Leg (17), insert the barrel of the M8 x
55mm Bolt Set (82) through both parts.
Next, slide a 7mm Spacer (55) and an M8
Washer (69) onto the end of the barrel of the M8
x 55mm Bolt Set (82). Then, turn the screw of
the Bolt Set a few turns into the barrel.
Do not
overtighten the Bolt Set; the left Handlebar
Leg must pivot freely.
Attach the right Handlebar Leg (not shown)
to the Right Pedal Leg (not shown) in the
same way.
See step 7.
Tighten the four M8 x 38mm Button
Bolts (58).
10. While another person holds the Console (74)
near the Upright (2), connect the Pulse Jumper
Wire (76) to the console pulse wire. Then, con-
nect the Wire Harness (77) to the console wire
harness. Insert the excess wire into the Upright.
Tip: Avoid pinching the wires.
Set the
Console (74) on the Upright (2). Attach the
Console with four M4 x 16mm Screws (47).
14
9
10
2
82
17
82
55
55
69
69
47
77
76
Pulse Wire
74
Grease
Avoid pinching
the wires
Console Wire
