QX1000 Manual III: Extension User's Guide
Extension User’s Menus
QX1000 (SW Version 5.3.x)
34
Distinctive Ringing
The
Distinctive Ringing
service of QX1000 allows you to assign
different ringing patterns to individual callers. The
Distinctive Ringing
Settings
page provides the necessary settings to receive a distinct
ring
depending on the caller’s address.
The
Enable Service
checkbox enables the service. Other
components on this page are available only when this checkbox is
selected.
Nick Name
requires the callers nickname (if any).
Ringing Pattern
lists the possible ringing patterns that may be
assigned to a specified caller.
Preview
allows you to play the ringing pattern directly or to save it to a
PC.
Fig. III-25 Distinctive Ringing page
Please Note:
All phones attached to the extensions in the Many Extension Ringing/Call Hunting table will ring with the pattern defined for the
individual caller to that extension.
Call Hunting
The
Call
Hunting
service provides the possibility of an incoming call consecutively ringing on several extensions depending on the calling party. The
Call
Hunting
page contains a table where all the participants in the call hunting group for the corresponding extension should be defined.
Attention:
By configuring the
Call
Hunting
service,
Unconditional
Call
Forwarding
and
Many Extensions Ringing
automatically will be
disabled on the current extension.
Selecting
Enable Service
activates the Call Hunting service on the
current extension.
The table displayed here lists the extensions where the call must be
consecutively duplicated in case of a call from the corresponding
caller.
Line Status
indicates if the extension is
Attached
,
Not
Attached
or Attendant. An extension cannot ring if it is
Not
Attached
.
The administrator must attach it to the line from the
Extensions
Management
page.
When the order of entries in the
Call To
table is defined in the
consecutive ringing order, the
Move Up/ Move Down
becomes
available. This will move the checked
Call To
extension either one
level up or down.
Fig. III-26 Call Hunting page
Add
opens the
Add Entry
page to add called extensions (an attendant
or a user extension). It has manipulation radio buttons to select the
type of extension to be added to Call Hunting. It contains the following
components:
•
The
Call To
drop down list contains QX1000’s attendant or user
extensions, depending on the radio button selected.
It is possible
to add the same extension more than once to the
Call To
table.
The extension will ring, depending on the order, as often as
configured.
•
The
Duration
drop down list is only available for user extensions
only. It is used to select the period (in seconds) for which the
corresponding user’s extension should ring.
Fig. III-27 Call Hunting – Add Entry page
