- 10 -
Main features of this device:
• 4,5V operation via transformer
• Body epilation head - 28 tweezers
4 | Start-up
• If you are using the appliance for the first time or if the battery has not been used
for a long time, recharge it completely (at least 12 hours). Never charge the appli
-
ance for more than 24 hours.
• The room temperature must be within a range of 5°C to 40°C (40°F to 104°F)
• Use only the power adapter supplied to charge the appliance. Check that the local
power voltage corresponds to the voltage indicate on the power adapter data
plate.
CHARGING:
1.
Turn the appliance off using switch (E).
2.
Plug the power cable (J) into the receptacle (H) on the charging stand.
3.
Then plug the transformer into the wall receptacle (power source).
4.
Put the appliance on the charging stand (G) while the body‘s back touching con-
tacts (I). The red charge indicator light (D) comes on during charging. At the end
of the charging, the charging warning light will turn green.
5.
Unplug the power adapter cable from socket (H) of the charging stand and unplug
the adapter plug from the wall outlet. The device is now ready to be used. The
completely recharged appliance may be used cordlessly for approx. 45 minutes.
Recharge the battery only when its capacity is completely exhausted. This
will prolong its service life. Do not recharge it daily.
4.1 | Operating instructions
Hair Removal
For best results, it is recommended to take a hot bath or shower in order to open
the pores. Your skin is then clean and supple, and thus ideally prepared for hair
removal. The appliance may be used on wet or dry skin, with equal results.
1.
Take off the cover (A).
2.
Turn the appliance on using switch (E).
3.
Set speed. Click (E) once for fine hairs. Another click for the coarser hairs. To stop
the operation press on the switch again.
4.2 | Recommendation for Use
- Use the appliance at the optimal epilating angle (80° to the skin).
- Hold the appliance in a relaxed and comfortable manner. Do not apply pressure.
For your safety, the appliance slows down and the rotation stops when you apply
excessive pressure.
- Make small circular movements - as if brushing or wiping - in the direction of the
hair growth.
