3. Remove the power cord from the engraver.
4. Remove the 6 #2 Phillips screws which secure the left hand side access panel. There are 4
on the side and 2 on the rear.
5. Move the lens carriage to the center of the engraving table.
Note: We have included spare mounting mirror mounting screws for the mirror over the lens,
but because the screws are very small, it is a good idea to place a piece of paper or plastic on
the table surface to prevent the screws from falling through the holes in the table.
6. With the provided 5/64 Allen wrench, remove the 4 mounting screws which attach the mirror
retainer to the mirror holder. As the screws are removed, place them on the table surface.
Do not leave them in the mirror retainer.
7. Carefully remove the mirror retainer from the mirror mount.
8. Remove the o-ring from the rear of the mirror
9. Remove the mirror from the mirror mount
10. Remove the un-mounted replacement mirror from the package.
11. Install the replacement un-mounted mirror in the mirror mount, shiny side down. When
looking at the lens carriage assembly from the top, you should see the dull or frosted side of
the optic.
12. Place the o-ring in the mirror retainer.
13. Gently place the mirror retainer over the mirror, ensuring that the o-ring is in place.
14. Install the 4 mounting screws, but do not tighten at this time.
15. Once all of the mirror mounting screws have been installed, gently and evenly tighten the
mirror mounting Allen screws. DO NOT OVER TIGHTEN.
NOTE: Because the position and alignment of this mirror is fixed, there is no need to perform
an alignment at this step in the process.
16. On the far left hand side of the X-Axis assembly, is a mirror mount. This mirror mount is
made of 2 components. The Mirror support and the Mirror mount.
a. The Mirror support is Brass in color and has knurled ridges around the outside,
similar to a quarter.
b. The Mirror mount is aluminum in color and has NO knurled edge.
