Pearl-2 User Guide
Set up traffic shaping
5. Enter the following:
l
Destination multicast IP address.
l
Audio port number through which the audio will stream.
l
Video port number through which the video will stream.
Audio and video use nearby port numbers (<port number>and <port 2>). The minimum
distance between audio and video ports must be 2.
6. Click
Apply
. An SDP file is generated.
7. From the channel's
Status
page, click the SDP file to download it. Provide the SDP file name and
location if prompted.
8. Share the file with your viewers and when you're ready to start streaming, select
Start
.
Set up traffic shaping
If you're multicasting to set-top boxes that have 10/100 Mbps interfaces on the same Gigabit Ethernet and
you notice frames are dropping, you can limit the bandwidth of the stream using traffic shaping to adapt for
391
