Standalone VGA Grid User Guide
AFU to an FTP server
l
l
l
AFU to an FTP server
This procedure assumes you have completed the steps in
and wish to continue
with configuration of upload to an FTP Server.
To configure upload to an FTP server:
1. Select
FTP Client
from the protocol drop down list in the Automatic File Upload configuration page;
the lower half of the page reflects the selection.
2. Specify the target
Server address
. If your system is configured with DHCP or has a valid DNS
), you can use the server’s fully qualified domain name instead of
the IP address.
3. Specify the
Server Port
used for the target FTP server. The standard port is 21.
4. Enter the FTP account username in the
Login
field.
5. Enter the FTP account password in the
Password
field; the characters are masked with dots.
6. Select
Use temp file
to name files with a temporary filename extension (.part) on the server until
upload is complete.
7. Click
Apply
; if there are any problems the system notifies you with a message: One or more parameter
values are not valid and those were not applied!
The following table describes the options applicable to configuring upload to an FTP server.
227
