page | 5
© 2016 Episode®
LS4, LS6, and LS8 speakers can be
connected to either channel.
The ES-LS-BSUB-12 or ES-LS-HSUB-10
must be connected to Channel 1 of the
Crown amp.
LS4, LS6, or LS8 may be connected to
Channel 2.
+ -
+ -
+ -
+ -
+ -
+ -
+ -
+ -
+ -
+ -
+ -
+ -
-
+
or
+ -
DSP Presets
The CR-CDIX000-LSCAPE comes preloaded with EQ presets that allow for the sound to be tailored to the system.
Using these presets will ensure that the best sound possible is being achieved by the system.
Using Presets
1.
Press Sel/Enter on the front of the amplifier.
2.
Press Next/Down until the word PRESET appears on the display.
3.
Press Sel/Enter on the front of the amplifier.
4.
Press Next/Down or Prev/Up until the name of the desired preset appears on the display.
5.
Press Sel/Enter on the front of the amplifier.
6.
The chosen preset name will appear on the display.
DSP Notes
• We do not recommend mixing LS4, LS6, or LS8 satellites on the same amplifier channel as custom speaker
settings cannot be properly enabled.
• If you are using a subwoofer in your installation, it MUST be connected to Output #1.
• For any changes beyond the presets, the front panel controls, or System Architect Software must be used.
Refer to the included Crown manual for details.
Selecting a Preset
Use this chart to select the preset that is appropriate for the system. The channel 2 column shows the speaker and
appropriate preset to use based on the speakers connected to channel 1.
NOTE:
We do not recommend mixing LS4, LS6 and/or LS8 on the same channel.
DEFAULT DEVICE FILE
Preset #
Preset
Name
Input
Mode
Output
(Voltage)
Speaker Hookup Configuration/
Comments
Additional Notes/Comments
1
DSP OFF
Stereo
Channel 1=8/4
Ω
No DSP
Channel 2=8/4
Ω
No DSP
2
LS4SATS
Stereo*
Channel 1=70V
LS-SAT-4 satellites in 70V tap settings
connected on both channels
Allows individual channel level control via
front panel volume potentiometers
Channel 2=70V
DSP settings for “flat response” tonal
balance
* Can be used with or without the use of
supplied input summing cable
3
LS6SATS
Stereo*
Channel 1=70V
LS-SAT-6 satellites in 70V tap settings
connected on both channels
Allows individual channel level control via
front panel volume potentiometers
Channel 2=70V
DSP settings for “flat response” tonal
balance
* Can be used with or without the use of
supplied input summing cable
4
LS8SATS
Stereo*
Channel 1=70V
LS-SAT-8 satellites in 70V tap settings
connected on both channels
Allows individual channel level control via
front panel volume potentiometers
Channel 2=70V
DSP settings for “flat response” tonal
balance
* Can be used with or without the use of
supplied input summing cable
