page | 11
© 2015 Episode®
Hum or buzzing sound is
heard.
Check RCA input cables by removing them one
at time (powering down the amplifier before
disconnecting) and checking to see if a connection or
cable is to blame.
No audio from speakers.
Verify speakers and wiring connections. Bypass
volume controls and test output with one speaker on
known good wire run.
Verify correct source operation and input wiring. Turn
volume in source up to an audible level.
Is STATUS LED purple? Amp is in Mute Mode. Unmute
or increase volume.
Is STATUS LED red? If so, see section above, “STATUS
LED is RED”.
SPECIFICATIONS
Rated Power
60 Watts @ 70V / 80 ohms minimum
Distortion
THD+N less than 1%
Input Sensitivity
Unbalanced Inputs (RCA and 3.5mm) 550mV
Balanced input
775mV
Input Impedance
Unbalanced Inputs (RCA and 3.5mm) 20KΩ
Balanced input
40KΩ
Auto On (Audio sense) Sensitivity
4mV
S/N Ratio Reference to Rated
Power
Unbalanced Inputs (RCA and 3.5mm) 85dB
Balanced input
87dB
Frequency Response
50Hz – 20KHz
Power Supply AC Main Input
100Vac – 240Vac, 1A, 50Hz – 60Hz
Power Consumption
Typical 30W
Fuse Rating
T1A L 250V
Dimensions:
9”W x 6.4”H x 1.75”D (without mounting ears)
10”W x 6.4”H x 1.75”D (with mounting ears)
Weight
5 lb.
Certification
TUV under UL 60065; UL 2043, plenum rated
(amplifier only)
© 2015 Episode®
