page | 8
CONNECT
!
CAUTION:
All connections and switching must be done with the amplifier
turned off. Connect the power cord last to ensure that the amplifier is off during
connection and set up.
256
Source
Power
Control System
• Connect source input via balanced line level, 3.5mm stereo or unbalanced
RCA.
• To control the amplifier, connect a control system to either the IR input, or
RS-232 input.
• Observing proper polarity, connect the speakers to the rear of the amplifier’s
phoenix connector.
• Lastly, connect power to an outlet with surge protection.
!
ATTENTION:
Do not connect more than one amplifier to the power supply.
Balanced Line Level
Tip
Sleeve(s)
Ring
Ring
Tip
Left
Right
Connect Tip to (+), Ring to (—), and the sleeve to ground.
3.5mm stereo
Use a 3.5mm stereo audio cable or customize the length of the cable, following the
pinout below.
Sleeve ( )
Ring (-)
Tip (+)
AC Outlet
Unbalanced
