page | 9
© 2015 Episode®
Unbalanced RCA line level
Use high-quality RCA cables that feature low impedance with adequate shielding
and high-quality connectors. If custom wiring, follow the wiring diagram below for
pin-out.
SLEEVE
TIP
TIP
SLEEVE
Speaker Outputs
Use 14–18 gauge stranded two-conductor speaker wire for all high level
connections. Ensure that at least 2" of each conductor are separated at each
connection. Only strip away 1/4" of insulation from each conductor to prevent
them from touching. Connect the appropriate conductor to each screw terminal,
observing correct polarity.
CONFIGURE
IR & RS-232 Control
To configure the amplifier, connect a control system via IR or RS-232 to send
the desired command codes. Control protocols are available for download on
the ECA-70VMINI-60W product page. Follow the control system manufacturer
instructions to configure commands for use.
List of Configurations
• Power Status
• Volume Level
• Input Selection
• Bass/Treble Level
• Auto Power Enable/Disable
Save Configurations
To save any changed configurations send the discrete Power OFF or Power Toggle
command. The configurations will be saved when the Auto OFF command is
activated after 15 minutes of inactivity.
The following settings can be saved in non-volatile memory:
• Current Audio Input
• Volume Level
• Bass and Treble
© 2015 Episode®
