CDMA FWT SXT-2180
5
Technical Manual
. Hidden Menu
Ⅱ
*Note: User MUST input the security lock code when accessing below menu options.
Emergency
‘##01’
- In the Emergency Menu state, you can store 3-address.
- Press 1~3 key to select an address slot, and then wait until you have heard a security tone. It likes as short melody.
- Enter the security lock code, and press desired Emergency Number and then press ‘
À
’ to save.
- If you press ‘#’ to release.
Ex) ‘##011911*’ – Store number ‘911’ to 1st Emergency Slot.
HOT Line
‘##02’
- In the Hotline Menu state, you can store 1 address.
- To set up the hotline, you should follow two steps
1. Set a hotline number which will be dialed automatically whenever you pick up the handset.
2. Set a hotline time to delay between picking up handset and dialing a hotline number.
- After heard confirmation tone for a lock code, You can set a Hotline number.
- And then press
À
to store it in a memory for preserving it on power-on/off cycle.
- If you press ‘#’ instead of
À
, it will be released.
- And then if you stored a hotline number by pressing
À
, you should select hotline delay time from 1sec. to 9sec. Just
press one key from 1 to 9 please.
- And then press
À
to store your selection.
- If you didn’t select the delay time, it will be set up default time on 2sec.
Ex) ##02
Î
enter lock code
Î
39
À
+ confirm tone
Î
4 +
À
- This example shows you a hotline number was saved with the number are “39533447” and delayed time is 4 secs.
A Key
‘##04’
- In the A Key menu, you can make sure that whether A key is valid or not.
- Input 26 digits of the A key what you want to valid.
- After finished input, press ‘
À
’.
- If the A key was valid, you can hear confirmation tone, but otherwise, you can hear an alert tone.
Ex)
##04
Î
26 digits (20 6 digits checksum)
Î
À
Master Clear
‘##05’
- In the Master clear mode, you can reset all setting value in Terminal.
- When it was done, the Terminal is set to Factory initiate.
NOTE: It will be erased all user data like as alarm, dial tone, etc.
Ex)
##05
Î
À
(Master Clear)
Test Call ( will be used in a lab like CDG2 )
‘##06’
- In the Test call mode, you can.
1
NEW 8K MARKOV
6
SO55 LOOP BACK
2
NEW 13K MARKOV
3 8K
LOOP
BACK
4 13K
LOOP
BACK
5 SO54
MARKOV
-
Pressing
‘
À
’ needs for make completed.
Ex)
##06
Æ
1~ 6
Æ
‘
À
’ (Test call)
Power Down Registration ( will be used in a lab like
CDG2 )
‘##07’
- In this menu support the testing of the power down registration,
When it was done, the Terminal will be going to the power down mode
and send the message of the power down registration.
Ex)
##07
Î
(Just press to this key to go for entering the power down)
