Contacts us : email :
sales@epochloadcell.com
, Ph: 080-23481364
SYSTEM CHECK (TEST)
r-AdC
1716
rECAL
ConF
?
L-dF
000
dIo
t-dIp
dis-c
88888
To access System check menu, navigate to menu -> tESt and press
ENTER/TARE
.
S.No.
Instruction
Display
1.
Navigate to
Raw ADC (r-AdC)
and press
ENTER/TARE
.
Raw ADC counts corresponding to load cell is
displayed.
2.
Navigate to
Restore Calibration (rECAL)
and press
ENTER/TARE
.
On pressing ‘
ENTER/TARE
’ Key, system asks
confirmation. If ENTER key is pressed, Original
Calibration values are restored.
3.
Navigate to
Load default (L-dF)
and press
ENTER/TARE
.
It will ask the password to conform to load default. On
entering the correct password, system asks
confirmation. If ENTER key is pressed, System loads
the factory set defaults to Calibration, Analog setup,
Serial Communication setup and System check
Parameters and also in to the memory.
4.
Navigate to
Display check (dis-c)
and press
ENTER/TARE
.
The all LED will be ON at the same time, for checking
purpose.
5.
Navigate to
DIO check (dIo)
and press
ENTER/TARE
.
Navigate to “t-doP” to test digital output.
Output can be checked by pressing Up key.
Navigate to “t-dIp” to test digital input.
t-dop