Introduction
EP-6WEA4/4I
Page 1-7
I/O Shield Connector
The EP-6WEA4/4I is equipped with an I/O back panel. Please use the appropri-
ate I/O shield (figure 3).
ATX
POWER SUPPLY
Power-On/Off (Remote)
The EP-6WEA4/4I has a single 20-pin connector for ATX power supplies. For
ATX power supplies that support the Remote On/Off feature, this should be
connected to the systems front panel for system Power On/Off button. The
systems power On/Off button should be a momentary button that is normally
open.
The EP-6WEA4/4I has been designed with “Soft Off" functions. You can turn Off
the system from one of two sources: The first is the front panel Power On/Off the
button, and the other is the "Soft Off" function (coming from the EP-6WEA4/4I’s
onboard circuit controller) that can be controlled by the operating system.
Windows 95/98 will control this when the user clicks that they are ready to Shut-
down the system.
Figure 4: Simple ATX Power
ON/OFF Controller
J3
Case (chassis) Power
ON/OFF button
Figure 3: I/O back panel layout
parallel port
MIC
Joystick/Midi
port
USB port
COM1
VGA1
Speaker
Line_in
PS/2 Mouse
PS/2
KEYBOARD
Summary of Contents for EP-6WEA4
