26.01.07, SBS 32, Drills
Page 8 from 33
The correct clamping of the tool
The correct clamping of the work part
The correct cutting pressure and cutting speed
The adequate coolant lubricant
Warning!
An improper use can lead to heaviest injuries.
The rebuilding or the change of the performance data is forbidden and
endangers personnel and machine.
1.3
Danger, which can emanate from drill
Construction and building of the machine equate to level of technique. The
machine was checked of operating safety.
However there exist risks and dangers by the use:
Improper use and non
– observance of safety instructions can cause
extensive injuries like bruises, crops, fractures or separation of members
Risk of injury by kickback or derailing of work parts and/ or tool
Danger of electric shock by damaged and electric units
Risk of stumbling by about lying work parts or work part rests
A cant of work parts can cause heavy injuries
Danger for ears by loud noise (from 85 dB(A))
The running drill can capture work wear or long hair insert
Danger of cutting by arris work parts
Danger of accidents by damaged tool (f. e. stump, loose, chapped etc.)
During use of coolant lubricant exists the danger of skin diseases
By the maintenance and use of the machine dangers because of false use or
improper maintenance may encounter you.
Information
To avoid errors and dangers, all users who are assigned with the
assembly, the use and maintenance have to be qualified and read plus
understand the operating manual.
By improper use of the machine may:
Danger for body and life exist
The machine and other property can be endangered
The safe function of the machine can be affected
It is very important that you disconnect the machine for cleaning and maintenance
work.
Warning!
The machine only can be used with functioning safety equipment. The machine
must be disconnected directly if you notice damaged or failure safety equipment.
All special units that are mounted from the operator have to include the
accordant safety units. You are not allowed to derogate or avoid the safety units
of machine. The responsibility therefore is the operators.
