BEP_6.1_241111
9
2. Interactive Whiteboard ePresenter Usage
2.1. Terms of use
2.1.1. An interactive whiteboard must be used in a proper climate conditions listed below:
air temperature -
from + 10 ˚ up to + 35 ˚ C;
approximate humidity - from 40% up
to 80% at +25 ˚ C;
atmosphere pressure from 84.0 up to 107.0 kPa (630-800 mmHg. cent.).
2.1.2. The power supply of ePresenter EP03 is provided by PC via USB cable.
The power supply of ePresenter EP03M is provided by batteries
– four batteries of AAA
type. Also it may be powered by external power block: 6 V, 300 mA
2.1.3. If product was stored or delivered at a temperature less zero, it has to be kept
unpacked for four hours in a heated area. It is strictly forbidden to leave a product near the
source of infrared radiation or in hot places.
2.1.4. You should install and connect a product according to requirements specified in
current document.
2.2. Precautions for operation
2.2.1. The safe interactive whiteboard operatiing is provided by its design, correct electrical
network connection to, a safe electrical network and correct user activity.
2.2.2.
It’s strictly forbidden:
·
to leave a product without user’s watch for a long time;
·
to touch cables or contacts if the power is turned on;
·
to connect device to damaged electrical wall outlets;
·
to
look to projector’s length when it’s turned on. You may damage your eyes because
of the effect of bright light.
2.2.3. You should follow the SAFETY RULES when use this product:
·
do not leave this product without attendance until it in operating;
·
do not let the student operate the devic
e without teacher’s supervision;
·
wall outlet which this device is plugged to must be cut-off quickly in case of fire or any
other emergency.
2.2.4. Do not try to repair a product yourself in case of malfunction. Please contact an
authorized service centre.
2.3. Transportation and Storage
2.3.1. IWB in manufacturer’s packing can be transported to any distance by any transport.
The transportation is regulated by rules established for each type of transport.
2.3.2 IWB transportation should be performed according to safety marks putting on the
package.
2.3.3. IWM should be stored by manufacturer or by customer in areas with a tempreture
from 5 to 40 C and with approximate humidity of 80%.
2.3.4. The storage area shouldn’t contain aggressive elements which could cause corrosion.
2.3.5. Packed IWB should be stored on racks less than eight tiers high.
