Edge Power Solutions
IPS-32-1 / IPS-32-2 / IPS-16 Installation Manual Revision 4.0 0322021
SECTION 1: Introduction
Edge Power Solutions rack mount power distribution units have been designed to p56VDC at up to 98W per output
(See
Note 1)
to low voltage DC devices such as:
•
GPON Optical Network Terminals
•
Distributed Antenna Systems
•
LED Lighting
•
CCTV
•
Wireless Access Point
•
Other applicable devices with similar input needs.
NOTE 1:
1.
IPS-16
a.
The maximum output per port is 95W
b.
The maximum combined output for 120VAC or DC RMS equivalent* input = 1400W
c.
The maximum combined output for 208-240VAC or DC RMS equivalent input = 1600W
2.
IPS-32-1 (DUAL 15A INPUT)
a.
The maximum output per individual port is 95W
b.
The maximum combined output for 120VAC or DC RMS equivalent* input = 2800W
(1400W INPUT 1 + 1400W INPUT 2)
c.
The maximum combined output for 208-240VAC or DC RMS equivalent* input = 3200W
(1600W INPUT 1 + 1600W INPUT 2)
3.
IPS-32-2 (SINGLE 20A INPUT)
a.
The maximum output per individual port is 95W
b.
The maximum combined output for 120VAC or DC RMS equivalent input = 1960W
c.
The maximum combined output for 208-240VAC or DC RMS equivalent input = 2800W Outputs
*DC RMS equivalent inputs via approved locking DC input connector only.
For Product Assistance or Technical Support call: 321-499-1919 - Option 4
1.1
Quick Installation Checklist
•
The following steps are recommended to quickly install the EPS-RM-1x(xx)-100W-(s) Power Supply Unit for use.
a)
Attach Rack Mount Brackets to the Power Supply Unit
b)
Mount the power supply unit in rack location
c)
Connect Safety Earth Ground connection to approved ground buss
d)
Connect devices to output connections using properly sized wire. (12AWG-24AWG)
e)
Connect to properly sized AC power source(s)
PAGE 1
