Page 23
EPS Stromversorgung GmbH
Alter Postweg 101 • 86159 Augsburg
Germany
Fon: +49 821 / 570451-0
Fax: +49 821 / 570451-25
PSI 9000 3U Series
1.9.3 Scope of delivery
1 x Power supply device
1 x Printed operating guide
1 x Share Bus plug
1 x Remote sensing plug
1 x 1.8 m USB cable
1 x Set of DC terminal covers
1 x CD “Drivers & Tools“
1 x AC connector plug (clamp type)
1 x Set for strain relief
1.9.4 Accessories
For these devices the following accessories are available:
Digital interface modules
IF-AB
Pluggable and retrofittable AnyBus interface modules for RS232, CANopen,
Ethernet, Profibus, ProfiNet, ModBus or Devicenet are available. Others upon
request. Details about the interface modules and the programming of the device
using those interfaces can be found in separate documentation. It is usually
available on the CD, which is included with the device, or as PDF download on
the manufacturers website.
1.9.5 Options
These options are usually ordered along with the device, as they are permanently built in or preconfigured during
the manufacturing process. Retrofitting upon request.
CABINET
19“-rack
Racks in various configurations up to 42U as parallel systems are available, or
mixed with electronic load devices to create test systems. Further information in
our product catalogue, on our website or upon request
HS
„High-Speed Ramping“
Increased output voltage dynamics through reduced output capacity.
NOTE: other output values, as well as ripple also increase. This is a permanent
feature which cannot be switched off.
3W
GPIB interface
Replaces the standard slot for pluggable interface modules by a rigidly installed
GPIB port. This option can be retrofitted upon request. The device will keep the
USB and analog interfaces. Via the GPIB port, it can only support SCPI commands.