2-32
Paper Handling
R4C4590
Rev. D
A5 size
HANDLE.FM
3/30/01
Pass 1
L
Proof Sign-off:
Takahashi, Kono
_______
Takahashi
_______
Hoadley, Courtier _______
4. Tear off the printed pages.
5. Press the
Pause
button to turn off micro-adjust mode.
When you resume printing, the printer automatically feeds the
paper back to the top-of-form position and begins printing. Your
tear-off position setting remains in effect until you change it, even
if you turn off the printer.
Adjusting the printing position
The printing position is the position on the page where the print
head actually prints during a print job. You can change the current
vertical printing position temporarily by using the micro-adjust
feature as described in the steps below.
Note:
Your printing position setting is in effect only until the next time you
load paper or turn off the printer.
1. Make sure that the printer is not printing. If it is, press the
Pause
button to stop printing.
2. Hold down the
Pause
button for about three seconds. The
Pause
light begins flashing and the printer enters the micro-
adjust mode.
3. If necessary, open the printer cover to check the printing
position, and press the
LF/FF
[
D
] button to feed paper forward
or the
Load/Eject
[
U
] button to feed paper backward.
4. When your paper is positioned correctly, press the
Pause
button to turn off micro-adjust mode and resume printing.
