2. Place slides in the holder, base side facing down as
shown below.
NOTE: The base side of the film is the side where
the film maker's name and film ID numbers can be
read correctly. Also, when you look at an image on
the film from the base side, the image should appear
normal, not reversed.
NOTES:
•
Make sure the document cover is completely closed; otherwise you cannot obtain
proper colored images.
•
A newton ring (ring-shaped stripe pattern) may appear in the scanned image. To
remove the newton ring, place the film with the base side facing up and preview using
the Thumbnail Preview; then reverse the previewed image by using the
Mirroring
button.
SCAN 35 MM NEGATIVES AND FILM STRIPS
1.
Slide the edge of the strip into the 35 mm film
holder, base side facing down. Then place it so
that the entire frame is positioned inside the film
holder.
2. Place the film holder on the document table so that the
triangle mark on its tab is aligned with the triangle on
the document table. The projection on the tab then goes
into the hole on the document table.
