Printing
l
Regular gaps
occur in
the printout.
One-inch skip-over-perforation may be set. Set DIP switch
1-8
off.
l
Skip-over-perforation is set, but the perforation does not fall in
the center
of
the skip.
Make sure the page-length DIP-switch setting matches the
page length of your paper. See page
3-7.
If your application program is setting the top and bottom
margins, set DIP switch 1-8 off.
l
Vertical printed lines do not align.
Turn DIP switch 1-5 on for unidirectional printing.
l
Printing starts too low on the
page,
or the bottom part
of
one
page is printed at the top
of
the next page.
Be sure to choose
the
correct printer when you choose a printer
from your application program’s menu. See page
1-14.
Use your application software to specify the type of paper
you are using (single sheet or continuous).
Use your application software to reduce or eliminate
the
top
margin and to reduce the page length or lines per page
setting.
l
When clearing the
buffer,
you also lose the top-of-form.
Always advance the paper to the top of the next page with
the LF/FF button before clearing the buffer.
Note: You can check the operation of your printer using the self
test. (See Running
the
self test in Chapter 1.) If
the
self test
works properly, the printer is operating properly, and the
problem probably lies in the computer,
the
software, or
the
cable. If the self test does not work,
contact
your dealer.
Troubleshooting
6 - 7
Summary of Contents for 5000/5500
