86
Presenting from a Memory Card, Digital Camera, or External Drive
Inserting a Memory Card in the
Projector
Follow these steps to insert the memory card in the projector:
1. If necessary, insert the card into a PC card
adapter. (ATA flash cards don’t require an
adapter.)
2. Insert the card (with the adapter) into the projector with the label
facing up. The projector does not have to be turned off before
inserting the card.
Removing a Memory Card
When you’re done using the projector and want to remove the
memory card, follow these steps.
1. Make sure the card is not in use (the indicator light next to the
card slot should be off).
2. Press the eject button above the card slot.
The button pops out.
3. Press the button again. The memory card is released, and you can
remove it from the slot in the projector.
4. To remove the card from the adapter, pull
it out as shown:
note
If a digital camera is
connected to the projector,
disconnect it before
inserting the memory card.
The memory card is not
functional when a digital
camera is connected.
caution
Never force the card into the
slot; you could damage the
projector.
Eject button
note
If you are using CardPlayer,
highlight the
EJECT
button
and press
Enter
on the
remote control. Then wait
for the indicator light to go
off before you eject the card.
Banff-Toronto User's Guide.book Page 86 Thursday, January 20, 2005 5:00 PM