70
Presenting Through a Wireless Network
5. To enable your computer to find the projector on the network,
you need to enter an ESSID, which is the SSID name of your
access point or the name of your AirPort network. (The name of
your AirPort network may be different from that of your AirPort
base station; select your base station in the AirPort Admin utility
and click
Configure
to check the name of your network.)
Highlight the
ESSID
text box, press
Enter
, and enter a name.
When you’re done, press
Enter
. Note that the ESSID is
case-sensitive (if you enter the name in uppercase on the
projector, you must type it the same way on the computer
connecting to the projector).
6. If you want to create a password for remote access to the
projector, highlight the
Password for WEB control
text box and
press
Enter
, and enter a password of up to 8 alphanumeric
characters. When you’re done, press
Enter
.
7. If you want to set up a security keyword so that only people who
are in the same room as the projector can access it, turn
Projector
keyword
on. Then when you want to connect to the projector, it
displays a randomized four-digit number or “keyword” on the
screen. When prompted by NS Connection, you can enter the
keyword on your computer to connect (see page 86).
8. If your access point assigns IP addresses automatically, turn on
DHCP
. Otherwise, turn off DHCP and enter the following
information manually:
■
IP address
: Type in the IP address you want to assign to the
projector. It must be formatted like other addresses on the
network; the first two segments (XXX.XXX) should match
the first two segments of the IP address for your access point
or AirPort base station. The last segment should be unique.
■
Subnet mask
: For example: 255.255.255.000, but this
depends on how your network is set up.
■
Gateway address
: Enter the IP address that was assigned to
the access point or AirPort base station when it was set up.
note
The projector keyword
changes each time you turn
the projector off and then on
again, or remove and
reinsert the 802.11g card.
Check the keyword on the
EasyMP Network screen
whenever you start EasyMP,
and enter that keyword on
your computer. You can’t
connect using a previous
keyword.
note
For specific details about
your network, please consult
your network administrator.
If you don’t know your
gateway or access point
address, see page 76. If you’re
using AirPort, start the
AirPort Admin utility, select
your base station and click
Configure
. Then click the
Network
tab to see your
base station’s IP address.
Summary of Contents for 835p - PowerLite XGA LCD Projector
