Presenting Through a Wireless Network
75
10. If your access point uses DHCP, select
Obtain an IP address
automatically
. Otherwise select
Use the following IP address
and enter the required information:
■
IP address
: Type in the IP address you want to assign to the
computer. It must be formatted like other addresses on the
network; the first two segments (XXX.XXX) should match
the first two segments of the access point’s IP address and the
last segment must be unique.
■
Subnet mask
: For example: 255.255.255.000, but this
depends on how your network is set up.
■
Default gateway
: Enter the IP address that was assigned to
the access point when it was set up.
11. When you’re done, click
OK
.
12. Click the
Wireless Networks
tab.
(If you don’t see this tab, you may need to enable your wireless
card or adapter by clicking
Configure
to access the device
settings; then follow any instructions on the screen to enable the
device.)
You see a screen like this:
note
For specific details about
your network, please consult
your network administrator.
note
If you don’t know your
gateway or access point
address, see page 76.
Summary of Contents for 835p - PowerLite XGA LCD Projector
