Printing
Problem
Solution
The print position is
not what you
expected
(continued).
Page length does not
Check the page length set by your
match the length
of
the
application software and adjust it if
paper.
necessary.
Regular gaps occur in
the printout.
Skip over perforation is
set, but the perforation
does not fall in the
center
of
the skip.
If you are using the cut sheet feeder, the
self test function prints the number of
printable lines that can fit on a single
sheet. Use this feature to determine the
correct page length setting. See Chapter 3.
One-inch skip over perforation may be
set. Set DIP switch 2-3 to off.
The loading position of the paper may be
too high or too low. Use the micro-
adjustment feature to reset the loading
position so that the perforation is
centered within the skip area.
Your application program may be setting
the top and bottom margins. If this is the
case, turn off skip over perforation by
setting DIP switch 2-3 to off.
7-12
Troubleshooting
