4. Position one of the cache chips over the first socket as shown
below, aligning the pins on the chip with the holes in the
socket. Make sure the small notch on the end of the chip is
aligned with the corresponding notch on the socket.
5. Gently press the chip halfway into the socket (to make sure
it is correctly aligned). If the chip goes in at an angle,
remove it and try again.
6. When the chip is properly positioned, push down firmly on
both ends to make sure it is well-seated.
7. Repeat steps 4 through 6 for each of the remaining chips.
8. Change jumpers J23, J24, J25, and J26, as described on
page 3-8, to match to the amount of cache you installed.
9. Replace any option cards you removed. See page 3-15.
10. Run SETUP to enable the
External Cache
option and
check that the
System shadow
and
Video shadow
options are
enabled. You select these options from the
Memory
Cache and
Memory Shadowoptions
on the
Advanced System Setup menu. Make sure you save your
settings as you leave SETUP. (See Chapter 1.)
Installing and Removing Options
3-23
Summary of Contents for ActionTower 3000 Computer
Page 1: ......
