EPSON AcuLaser C2000 / AcuLaser C1000
Revision E
Troubleshooting
Printer Message
113
3.2.2.2 Details of Status Messages and Processing
(AcuLaser C1000)
Reset
Description:
The printer is being reset.
This status occurs as a result of clearing EEPROM, but
does not occur by user's operation.
Warming Up
Description:
The printer is warming up.
Processing:
After warming up for approximately two and a half
minutes, the printer will automatically get ready to print.
Calibrating Printer
Description:
The printer engine is being adjusted.
Engine adjustment is performed automatically in the
following situations.
• When power to the printer is turned on
• When a cover is opened and closed except in the case
of a paper jam
• When the printer is recovered from standby, provided
that 100 sheets have been printed or 24 hours have
elapsed after the last adjustment.
Processing:
After Calibrating Printer for approximately one minute, the
printer will automatically get ready to print. Never open
any covers during this period.
Cooling Down
(Status Monitor will display this status as “Calibrating Printer”)
Description:
The printer engine is being cooled down.
• The printer engine is automatically cooled down when
internal temperature is too high to print transparencies.
Printing will be stopped until the internal temperature
becomes suitable for printing transparencies.
An irregular temperature of the fuser is being adjusted.
• If there is an irregular temperature of the fuser after
returning from the standby mode, the engine will
operate until the temperature is evened up.
Processing:
In the case of “cooling down”, the printer becomes ready
automatically after approximately one minute and resumes
printing.
In the case of “adjusting irregular temperature”, the printer
becomes ready automatically after 2 to 10 seconds and
resumes printing. This time depends on the elapsed time
and the number of printed sheets after return from the
state of standby.
Standby
Description:
The printer is in standby mode.
Processing:
The printer becomes ready to print upon receiving printing
data.
Ready
Description:
The printer is ready to print (normal status).
Other status messages
Printing Job
Engine Operating
Non-active Interface
Summary of Contents for ACULASER COLOR 1000
