Special
Adjusts the print quality for special paper according to the paper type.
❏
1: Plain paper1
❏
2: Plain paper2 (default)
❏
5: Plain paper3
❏
6: Thin paper
❏
7: Thick paper1
❏
8: Thick paper2
❏
9: Thick paper3
❏
10: Plain paper3 (Improve thin lines)
❏
11: Thick paper (Improve fixing)
Printer Offset:
Feed Offset
Adjusts the start position for printing in the vertical direction. You need to adjust Feed Reg1
from Each Tray Offset before making this adjustment. The start position shifts down as the
value increases. This setting is available for single-sided printing and for the back of duplex
printing.
-3.5 to 3.5 mm (0.0 mm default)
Scan Offset
Adjusts the start position for printing in the horizontal direction. You need to adjust Scan Reg1
from Each Tray Offset before this adjustment. The start position shifts to the right as the value
increases. This setting is available for single-sided printing and for the back of duplex printing.
-3.5 to 3.5 mm (0.0 mm default)
Feed Offset Back
Adjusts the start position for printing in the vertical direction. You need to adjust Feed Reg2
from Each Tray Offset before making this adjustment. The start position shifts down as the
value increases. This setting is available for the front of duplex printing.
-3.5 to 3.5 mm (0.0 mm default)
Scan Offset Back
Adjusts the start position for printing in the horizontal direction. You need to adjust Scan Reg2
from Each Tray Offset before this adjustment. The start position shifts to the right as the value
increases. This setting is available for the front of duplex printing.
-3.5 to 3.5 mm (0.0 mm default)
Each Tray Offset:
Adjusts the start position for printing for each paper source.
Feed Reg1
Adjusts the start position for printing in the vertical direction. The start position shifts down as
the value increases. This setting is available for single-sided printing and for the back of duplex
printing.
>
>
202