AN2 Series
Installation Instructions
10
Installing Projector
1.
Attach projector interface (T) to projector using four
M4 x 12mm Phillips cap head screws (V). (See Figure 10)
Figure 10
NOTE:
Make sure projector mount is in UNLOCKED position
and remove key from projector mount.(See Figure 11)
2.
Lift projector with attached interface (T) and slide buttons on
interface into slots on boom projector mount (S). (See
Figure 11)
3.
Slide latch to LOCKED position to lock projector in place.
(See Figure 11)
4.
Add and route cables following instructions included with
the projector.
NOTE:
Do NOT place extra cable length behind the sensor
bracket.
Figure 11
5.
Place a level on top of the boom arm mount and level the
mount after the projector is installed. (See Figure 12)
5A. Tighten nut to increase boom arm angle.
5B. Loosen nut to decrease boom arm angle.
6.
Place a level on top of interface (T) and level. (See Figure 12)
CAUTION:
While leveling mount:
•
Ensure nut is fully engaged onto bolt, and
AT LEAST
ONE
thread appears through nut.
•
DO NOT
over tighten nut! Over tightening
WILL
damage wall behind mount.
Figure 12
(V) x 4
1
(T)
Buttons
Slot
(S)
(T)
2
LOCKED
3
Latch
Slot
UNLOCKED
5A
5B
5B
5A
