Settings item
Settings value
Explanation
Page Margin
3 mm
*
Select the top, bottom, left, and right margin values.
For a cut sheet, the top, bottom, left, and right margin values are 3 mm
regardless of the settings.
5 mm
Smoothing
On
This setting is enabled when
Resolution
is set to
Standard
and there is no
resolution specification in the sent print data. Setting this to
On
will print at
the maximum resolution corresponding to the Paper Type setting for the
paper selected in
Paper Source
, but depending on the data, this may result
in a long print time, or failures in printing because of insufficient memory.
Off
*
Base Output Size
Auto
*
The hard clip area of the PS command of the data becomes the base output
size. The actual output size depends on the Page Margins option. When the
data does not contain a PS command, the smallest rectangle area
of in
the following illustration including the print object becomes the base
output size.
A Series
The compatible standard sizes for the selected
Paper Source
are displayed,
therefore select the Base Output Size. The actual output size depends on the
Page Margins option.
For a cut sheet, this setting is available only when the data does not contain
a PS command. If the data contains a PS command, this setting is not
available, and the hard clip area of the PS command becomes the Base
Output Size.
US-ANSI
US-ARCH
B Series (ISO)
B Series (JIS)
Others
User-Defined
Select this option when outputting at non-standard sizes. After selecting
this setting, set Paper Width and Paper Height. You can set in 0.1 mm
increments.
The actual output size depends on the Page Margins option.
Resolution
Standard
*
This setting is enabled when the resolution is not specified in the sent print
data.
Standard
will print at the resolution corresponding to the Paper Type
setting for the paper selected in
Paper Source
and the
Quality
setting.
300dpi
600dpi
1200dpi
SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
Using the Menu
153