Handling of Used
Consumables
If using the printer in an office or other business, dispose
of used consumables in accordance with laws and
regulations, such as by contracting an industrial waste
disposal company.
If using the printer in a domestic situation, place these in
a plastic bag, then dispose of in accordance with laws
and regulations as well as regional ordinances, and as
directed by local government.
Replacing Ink Cartridges
If any of the ink colors remaining amount falls below the
minimum amount, printing will not be possible.
If an ink cartridge remaining amount falls below the
minimum amount, you can continue printing after
replacing the ink cartridge.
If the remaining ink amount drops yet printing is
continued, then replacement of an ink cartridge during
printing may be required. When replacing ink during a
print job, you may see a difference in color depending
on the drying conditions. When this is not permissible,
we recommend first replacing the ink cartridge with a
new one before printing. The removed ink cartridge can
be installed again and used until the remaining amount
falls below the minimum amount. However, if an ink
cartridge with not much ink remaining is removed and
reinstalled, it may not be usable because some ink is
consumed to ensure the reliability of the printer.
Supported ink cartridges
U
Consumable Products” on page 218
c
Important:
Epson recommends the use of genuine Epson ink
cartridges. Epson cannot guarantee the quality or
reliability of non-genuine ink. The use of
non-genuine ink may cause damage that is not
covered by Epson's warranties, and under certain
circumstances, may cause erratic printer behavior.
Information about non-genuine ink levels may not
be displayed, and use of non-genuine ink is recorded
for possible use in service support.
Note:
You can replace the ink cartridges while viewing the
procedure on the screen. To view the procedure on the
screen, touch
Settings
-
Maintenance
-
Ink Cartridge(s)
Replacement
from the Home screen.
A
Make sure the printer is on.
B
Open the cartridge cover.
C
Remove the new ink cartridge from the bag.
Shake the ink cartridge for 10 seconds 30 times
horizontally in approximately 5 cm movements
as shown in the illustration.
c
Important:
Do not touch the IC chip on the ink cartridge.
You may not be able to print properly.
SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
Maintenance
186
