Quiet Mode:
Select
On
to reduce noise during printing, however, this may lower the print speed. Depending on
the paper type and print quality settings you selected, there may be no difference in the printer's noise
level.
Ink Drying Time:
Select the ink drying time you want to use when performing 2-sided printing. The printer prints the
other side after printing one side. If your printout is smeared, increase the time setting.
PC Connection via USB:
Select
Enable
to allow a computer to access the printer when connected by USB. When
Disable
is
selected, printing that is not sent over a network connection is restricted.
USB I/F Timeout Setting:
Specify the length of time in seconds that must elapse before ending USB communication with a
computer after the printer receives a print job from a PostScript printer driver or PCL printer driver.
If the job ending is not clearly defined from a PostScript printer driver or PCL printer driver, it can
cause endless USB communication. When this occurs, the printer ends communication after the
specified time has elapsed. Enter 0 (zero) if you do not want to end communication.
Related Information
&
Network Settings
Select the menus on the control panel as described below.
Settings
>
General Settings
>
Network Settings
You cannot change settings that have been locked by your administrator.
Wi-Fi Setup:
Set up or change wireless network settings. Choose the connection method from the following and then
follow the instructions on the LCD panel.
❏
Router
❏
Wi-Fi Direct
Wired LAN Setup:
Set up or change a network connection that uses a LAN cable and router. When this is being used, Wi-
Fi connections are disabled.
Network Status:
Displays or prints the current network settings.
❏
Wired LAN/Wi-Fi Status
❏
Wi-Fi Direct Status
❏
Print Status Sheet
User's Guide
Preparing the Printer
33
