Printing starts lower on the page than you expected, or the
bottom of a page is printed at the top of the next page.
Cause
What to do
The top and bottom margin
settings in your application
software may be incorrect.
Adjust them in your application
software.
Options
The perforation cutter is installed and the printer does not
feed continuous paper properly.
Cause
What to do
The perforation cutter’s
connector is not plugged
securely into the printer.
Turn off the printer then check the
perforation cutter connector.
The perforation cutter is installed and the paper is not cut
properly.
Cause
What to do
The printer driver setting is
not set correctly.
Select the paper source you want to
use in the printer driver. See Chapter 2.
You didn’t set the auto cut
mode.
Turn on DIP switch 3-7 to select auto
cut mode. However, any setting made
in the printer driver overrides the auto
cut mode setting.
You don’t set the page length
to match your paper.
Set the page length to match your
paper.
L
Peony
Rev.C
A5 size
Chapter 8
98/01/07
DR, pass 4
8-18
Troubleshooting
Summary of Contents for C204001 - DFX 8500 B/W Dot-matrix Printer
