Character Tables
These character tables are selected with the DIP switches or by using a
software command.
Note:
Characters for hex codes 00 through 7F for most tables are the same as those for
PC437. Therefore, some tables may only list characters for hex codes 80 through
FF.
Tables with an asterisk (*) after the table name are available only in some
countries.
When you select the IBM character table with DIP switch 3-6 as described
in Chapter 4, 00 to 1FH and 80 to 9FH are replaced for Table 1 selection,
as shown below. Also when Table 2 is selected with DIP switch 3-6, 00 to
1FH are replaced as shown below.
table 1
table 2
B
R
Peony Rev.C
A5 size
Appendix B
98/01/07
Pass 3
Printer Commands and Character Tables
B-7
Summary of Contents for C204001 - DFX 8500 B/W Dot-matrix Printer
