Version 2.61 Feb. 2008
6
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-T90)
4) Port information when using Ethernet port
The port information that can be set with the SetupPOS utility is as follows.
Item Setting
range
Output buffer length [byte]
32 to 1024
Output interval time [ms]
0 to 9999
The default settings are as shown in the following table.
Item Setting
range
Output buffer length [byte]
1024
Output interval time [ms]
2500
2.4 Device Settings
The following explanation is about the settings for TM-T90.
2.4.1 Usable Device Specific Settings
For the TM-T90, the following device specific settings are settable by the
SetupPOS utility. For the detail, please refer to the Section 2 of “EPSON OPOS
ADK MANUAL APPLICATION DEVELOPMENT GUIDE POSPrinter (TM
Series)”.
Tab Settings
Disable panel buttons
Assume print complete when data output finishes
Ignore firmware version check
Homogenize Error Codes
General
Output complete timeout
Paper Type
Paper
Paper Width [mm]: LineWidth [dot]: LineCharsList
Bitmap TMFlogo...
Method
Brightness
Primary
Color Bitmap
Secondary