A (pipe) character means
“either/or.” You have a choice
between two items separated by a
Brackets indicate that the enclosed
item is optional. If not entered,
the default value is used.
A complete list of EPCONFIG options is shown below. When
using EPCONFIG, you can enter more than one option at a time.
EPCONFIG
serial-number
N=E [SHOW] [RESET]
[NN=new-name] [NP=new_password] [RPT=NORP 1 RP]
[T=polling_time] [C=ethernet_type] [VA]
Each option is explained fully in the following sections.
Show Current Settings
EPCONFIG
serial-number
N=E SHOW
This command displays settings for the options described in this
chapter. It also shows the current master file server. Changing the
master file server is described earlier in this chapter.
EPCONFIG SHOW also displays the recommended settings for an
option that is usually not changed, network packet size. (Packet
size sets the size of packets that the Ethernet Card sends across
the network.)
If you have a unique configuration that requires changing the
packet size, call Epson Technical Support for further information.
2-10
Changing the Configuration
