Using the TEAR OFF button
Whether or not the printer is in tear-off mode, you can use the
TEAR OFF
button to advance continuous paper to the tear-off
position by following the steps below.
1. Make sure printing is finished. Then press the
TEAR OFF
button. The printer advances the paper to the tear-off edge
and the
TEAR OFF
light comes on.
2. Tear off all printed pages. If the perforation is not aligned
with the tear-off edge, adjust the tear-off position as
described in the next section.
3. When you resume printing, the printer automatically feeds
the paper back to the loading position and begins printing.
(You can also manually feed the paper back to the loading
position by pressing the
TEAR OFF
button again.)
Adjusting the tear-off position
If the paper’s perforation is not aligned with the tear-off edge,
follow the steps below:
1. Turn on the printer and select the desired tractor.
2-16
Loading and
Using Paper
Summary of Contents for DFX-5000+
