Area measurements
Overlapping multi-part forms with labels
Same as labels except for the following:
The label on your form should be placed within the shaded area above,
but not on the vertical or horizontal perforation.
Area measurements
label
B
A
E
F
D
C
A
13
±
3 mm (0.51
±
0.12 inch)
B
62.5 mm (2.46 inches)
C
4.2 mm (0.165 inch)
D
thickness of area where label is attached:
0.53 mm (0.02 inch) or less
E
from perforation to the top of the next overlapping form:
3.3 mm (0.13 inch) or more
F
from perforation to the bottom edge of the glue point area:
17 mm (0.67 inch) or less
G
from perforation to the bottom edge of the previous overlapping
form: 13.3 mm (0.52 inch) or less
H
total thickness including glue point dilation:
0.65 mm (0.026 inch) or less
perforation
the bottom edge
of overlapping
form
the top of
overlapping form
the bottom edge of
the glue point area
(side view)
backing sheet
G
A
H
Me-200
A
19 mm (0.748 inch) or more
B
21.2 mm (0.835 inch) or more
C
4.2 mm (0.165 inch) or more
A
A
R
Maple
Rev.D
A5 size
Appendix A
06/17/97
pass 0
Specifications
A-13
Summary of Contents for DLQ-3000+
