101
Light status
Condition/solution
The power light is on
The scanner is turned on and ready to scan
The power light is flashing
The scanner is scanning, initializing, or in standby mode
The power light is flashing
and the
!
error light is on
The scanner cover is open or a paper jam or double feed has occurred.
Make sure the scanner cover is closed and there is no jammed paper
inside. Remove and reload the originals.
The power light and the
!
error light are flashing at the
same time
A fatal error has occurred. Try the following:
• Check the scanner connection to your computer to make sure it is
secure.
• Turn the scanner off and then back on again. If the error continues,
the scanner may be malfunctioning. Contact Epson for support.
The power light is off and the
!
error light and
automatic
feeding mode light are on
The firmware update has failed and the scanner is in recovery mode.
Try updating the firmware again.
Parent topic:
Related references
Original Jams in Scanner
Where to Get Help
Related topics
Solving Scanning Problems
Check these solutions if you have problems scanning with your product.
Scanner Does Not Turn On or Turns Off Unexpectedly
Scanner Button Does Not Work as Expected
Scanning Software Does Not Operate Correctly
Cannot Start Epson Scan 2
Original Feeds Incorrectly in Scanner
Original Jams in Scanner
Scanning is Slow
Summary of Contents for DS-410
