tab. Make sure
Fine Reader
is selected as the
OCR Engine
setting and click
OK
twice. Try your scan
again using Epson Scan.
Parent topic:
Solving Scanned Image Quality Problems
Related references
Ripple Patterns Appear in an Image
You may see a ripple pattern (called a moiré) in scanned images of printed documents. This is caused
by interference from differing pitches in the scanner's screen and your original's halftone screen. To
reduce this effect, adjust these Epson Scan settings (if available) and try scanning again:
• Select the
Descreening
setting.
• Select a lower
Resolution
setting.
Parent topic:
Solving Scanned Image Quality Problems
Related references
Line of Dots Appears in All Scanned Images
If a line of dots appears in all your scanned images, clean the scanner glass with a soft, dry, lint-free
cloth or use a small amount of glass cleaner on the cloth, if necessary. Paper towels are not
recommended.
Caution:
Do not spray glass cleaner directly on the scanner glass.
Parent topic:
Solving Scanned Image Quality Problems
Related tasks
Scanned Image Edges are Cropped
If the edges of a scanned image are cropped, try the following solutions:
• Select
Auto Detect
as the Size setting (Epson Scan) or the Document Size setting (Document
Capture Pro or Document Capture).
• Adjust the cropping area shown in the
Crop Margins for Size "Auto"
setting in Epson Scan.In
Document Capture Pro, select
Detailed Settings
from the Scan window. Click
Configuration
and
86
Summary of Contents for DS-760
