Security Functions
33
f
Entering the Password
When the password entry screen is displayed, enter the password using the
numeric buttons on the remote control.
Enter the password by using the numeric buttons.
(With the EB-W6, enter the digit while holding down the
[Num] button.)
When you enter the correct password, projection begins.
Procedure
Attention
• If an incorrect password is entered three times in succession, the
message "The projector's operation will be locked." is displayed
for about five minutes, and then the projector switches to standby
condition. If this happens, disconnect the power plug from the
electrical outlet and then reinsert it and turn the projector's power
back on. The projector displays the password entry screen again
so that you can enter the correct password.
• If you have forgotten the password, make a note of the "Request
Code: xxxxx" number that appears on the screen and contact the
nearest address provided in the Support and Service Guide.
• If you continue to repeat the above operation and input the wrong
password thirty times in succession, the following message is
displayed and the projector does not accept any more password
entries. "The projector's operation will be locked. Contact Epson
as described in your documentation."
Summary of Contents for E-Torl EB W6
Page 1: ...1 User s Guide ...
