Projector Parts and Functions
16
Name
Function
F
USB-A port
(USB connector Type
A)
Use to connect a USB memory device for projecting
movies or images in Content Playback mode. It is also
used for batch settings and firmware update.
Use to connect the optional camera when using the
optional ultra short-throw zoom lens.
Provides a connection for a streaming media player to
power it.
Attention
• Use the USB cable supplied with or specified
for use with the device.
• Do not connect a USB hub or a USB cable
longer than 3 meters, or the device may not
operate correctly.
G
Service port
(USB connector Type
B)
This port is used for batch settings and firmware
update.
H
HDMI port
(HDMI)
Inputs video signals from HDMI compatible video
equipment and computers.
Connects the optional base unit of the Epson Wireless
Presentation System.
This port is compatible with HDCP2.3. (Audio is only
supported by PCM)
I
DVI-D port
(DVI-D 24-pin
single)
Inputs the computer DVI-D signals.
This port is compatible with HDCP1.4.
Name
Function
J
HDBaseT port
(RJ-45)
Use to connect a LAN cable to the optional HDBaseT
Transmitter. You can use a network cable up to 100 m
in length. To ensure proper data transmission, use a
Category 5e STP cable or better. However, operation is
not guaranteed for all input/output devices and
environments.
This port is compatible with HDCP2.3.
Check the following settings:
• To enable communication from the Ethernet and
serial ports on the transmitter, select
On
as the
Control Communications
setting in the projector's
Extended
menu.
s
Extended
>
HDBaseT
>
Control
Communications
• If you have connected an Extron XTP transmitter or
switcher, select
On
as the
Extron XTP
setting in the
projector's
Extended
menu.
s
Extended
>
HDBaseT
>
Extron XTP
K
LAN port
(RJ-45)
Use to connect a LAN cable to connect to a network.
Use a 100Base-TX or 10Base-T network cable.
To ensure proper data transmission, use a Category 5
shielded cable or better.
