Setting Up Monitoring Using SNMP
106
Network administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor projectors. If
your network uses this software, you can set up the projector for SNMP
monitoring.
a
Press the [Menu] button, select the
Network
menu, and press [Enter].
b
Select
Network Configuration
and press [Enter].
c
Select the
Notifications
menu and press [Enter].
d
Set the
SNMP
setting to
On
.
e
Enter up to two IP addresses to receive SNMP notifications, using 0 to
255 for each address field.
a
Do not use these addresses: 224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255). This projector supports
SNMP agent version 1 (SNMPv1).
f
Enter the SNMP
Community Name
up to 32 alphanumeric characters
long.
g
When you finish selecting settings, select
Complete
and follow the on-
screen instructions to save your settings and exit the menus.
g
g
Related Links
