Epson ELPDC21 User Manual Download

Page: 61 / 62

DECLARATION of CONFORMITY

According to 47CFR, Part 2 and 15

Class B Personal Computers and Peripherals; and/or

CPU Boards and Power Supplies used with Class B Personal Computers

We:

Epson America, Inc.

Located at:

3840 Kilroy Airport Way

MS: 3-13

Long Beach, CA 90806

Tel:

562-981-3840

Declare  under  sole  responsibility  that  the  product  identified  herein,
complies  with  47CFR  Part  2  and  15  of  the  FCC  rules  as  a  Class  B  digital
device.  Each  product  marketed,  is  identical  to  the  representative  unit  tested
and  found  to  be  compliant  with  the  standards.  Records  maintained  continue
to  reflect  the  equipment  being  produced  can  be  expected  to  be  within  the
variation  accepted,  due  to  quantity  production  and  testing  on  a  statistical
basis  as  required  by  47CFR  2.909.  Operation  is  subject  to  the  following  two
conditions  :  (1)  this  device  may  not  cause  harmful  interference,  and  (2)  this
device  must  accept  any  interference  received,  including  interference  that
may  cause  undesired  operation.

Trade Name:

EPSON

Type of Product:

Document Camera

Model:

ELPDC13/ELPDC21

FCC Compliance Statement

For United States Users

This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  a
Class  B  digital  device,  pursuant  to  Part  15  of  the  FCC  Rules.  These  limits
are  designed  to  provide  reasonable  protection  against  harmful  interference
in  a  residential  installation.  This  equipment  generates,  uses,  and  can  radiate
radio  frequency  energy  and,  if  not  installed  and  used  in  accordance  with  the
instructions,  may  cause  harmful  interference  to  radio  communications.

However,  there  is  no  guarantee  that  interference  will  not  occur  in  a
particular  installation.  If  this  equipment  does  cause  interference  to  radio
and  television  reception,  which  can  be  determined  by  turning  the
equipment  off  and  on,  the  user  is  encouraged  to  try  to  correct  the
interference  by  one  or  more  of  the  following  measures.

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

WARNING

The  connection  of  a  non-shielded  equipment  interface  cable  to  this
equipment  will  invalidate  the  FCC  Certification  or  Declaration  of  this
device  and  may  cause  interference  levels  which  exceed  the  limits  established
by  the  FCC  for  this  equipment.  It  is  the  responsibility  of  the  user  to  obtain
and  use  a  shielded  equipment  interface  cable  with  this  device.  If  this
equipment  has  more  than  one  interface  connector,  do  not  leave  cables
connected  to  unused  interfaces.  Changes  or  modifications  not  expressly
approved  by  the  manufacturer  could  void  the  user's  authority  to  operate  the
equipment.

For Canadian Users

General Notice