Setting the Projector
130
f
While holding down the [ID] button, press the button with the same number as the
projector ID for the projector you want to operate
Remote control operations for the projector with the selected ID are enabled.
c
When
Projector ID
is set to
Off
, you can operate the projector using the remote control
regardless of the ID setting selected using the remote control.
When the remote control ID is set to 0, you can operate all of the projectors regardless of the
projector ID setting.
Operating multiple remote controls at the same time can cause accidental operations due to
infrared interference.
Multi-Projection Connection Settings
Make the following settings on all connected projectors. The settings differ depending on whether or not
you use the interactive functions.
When using the interactive functions (
When not using the interactive functions (
)
When using the interactive functions
a
Press the projector's [Menu] button
Using the Remote Control
Using the Control Panel
Summary of Contents for ELPHD02
