Adjusting the Interactive Pen
86
Calibrating the Interactive Pen
Adjust the projector’s image before calibrating the pen.
There are two methods available for calibrating the pen;
Auto Calibration
and
Manual Calibration
.
When calibrating the pen for the first time, perform
Manual Calibration
for optimum calibration.
When calibrating the pen for the second time and after, perform
Auto Calibration
)
c
When the
Screen Type
is set to
16:6
, replace the soft pen tip with a hard pen tip.
Manual Calibration
a
Turn on the projector, and then press the [Menu] button
Using the Remote Control
Using the Control Panel
b
Select
Manual Calibration
from the
Pen/Touch
menu.
c
When multiple projectors are installed in parallel, you see a message prompting you to
temporarily hide the image for the projector installed next to it. When you see this message,
press the [A/V Mute] button to hide the image from the next projector.
Summary of Contents for ELPHD02
